OVERALL PROBLEMS WHEN OPERATION OF THE SWIMMING POOL
1. ARRANGEMENT:
There are 3 types of algae that can survive in aquariums: green, black and yellow. All three types can
be denatured in one way:
– First check the pH and correct for 7.2 to 7.6. Then use
the SOCK IT method to process.
– After adjusting pH sterilized by strong chlorine.
– After chlorine, scour the walls and bottom of the tank because algae or algae
grow on the walls and stairs of the tank.
2. DRAGON WATER:
There are many causes of turbid water.
– Due to the waste of many swimmers.
– The influence of algae.
– pH is too high.
– To solve this problem first check and adjust swimming pool water for
pH 7.2 ÷ 7.6 and total solute: 60 ÷ 100mg / l.
– Check for excess chlorine (2-3mg / l).
– If muddy water can be mossy, sterilize with high chlorine
content.
– If it is still opaque, check the filter system and may have longer filtration time
.
3. ALSO:
– Scaling may be white, gray or brown, as a result of high alkalinity
and pH to prevent scale concentration of 7.2 ÷ 7.6 and alkalinity of 60 ÷
100mg / l.
4. BREATHING:
– Contamination is usually caused by rust in water if the water in the tank is oxidized by
metal and metal oxide clings to the wall of the spill tank.
– To prevent stains always correct the water regime for the tank.
5. SURFACE:
Many times after swimming the swimmer’s eyes begin to red, it is very annoying for
the swimmer to do it due to the following reasons:
– pH is not correct.
– Too little chlorine.
9
To avoid that need:
– Check and correct the pH, the chemical after the bottle chemical containers
pH:
+ pH too high: for Sodium bisulfate
+ pH too low: for Sodium carbouate
For filtration system circulatory , the automatic set will automatically correct the pH
– Check the residual chlorine (1 ÷ 3 mg / l).
6. COLORED WATER:
Dark brown, mixed green.
– Check and adjust the PH: 7.2 ÷ 7.6 (preferably from 7.4 ÷ 7.6).
– Strongly disinfect the swimming pool using the SOCK IT method