KELAS-TAH3 tile adhesive: The KELAS-TAH3 high-grade tile adhesive is in accordance with European Standard EN 12004: 2001, C2TE high quality, with the following values:
STT |
Technical properties |
Value |
first |
Set time (start / end time) |
200/440 minutes |
2 |
Adhesive strength (after 28 days) |
1.5 MPa |
3 |
Bending strength (after 28 days) |
6 MPa |
4 |
Compressive strength (after 28 days) |
14 MPa |
5 |
Slippage |
0 mm |
3. Step 3: Preparation: – Tools: Fly, glue table, tape measure, ruler, container, glue machine, … – Check the surface clean, check the flatness with straight ruler in accordance with TCVN error of ± 0.5 mm. – Concrete wall, plastered mortar wall ≥ 75. – Cleaning the surface of the wall, the bottom of the pool. – Moisten the walls by spraying water. – Paving with water (18-22% of water compared to the amount of glue). Mix the glue into a homogeneous mixture, no lumps. Time is about 7 – 10 minutes |
|
4. Step 4: Covering: – Apply 2-3 mm thick adhesive to the surface of the wall and the bottom of the pool. – Create a flat surface, create surface adhesion with a pedestal. |
|
Step 5: Mosaic Tiling: – Position the brick wall with the line from left to right from the top down. – Mesh glue with mesh surface on flat glue. – Handle the two corners of the blister paste and ke in the straight line on. – Use a scissors table to gently pull on the tile surface in a diagonal style and ensure that the tablets stick to the glue. |
|
6. Step 6. Purge and clean (Make after Mosaic paste on glue 04 hours): – Wipe the surface before applying – Glue with clean water (water rate 28 – 30% compared to glue) – Use flexible plastic splinters to seal the circuit board into the mosaic circuit, filling the circuitry. glue-type cross-swimming swimsuit |